manual, the KN Vent/Air manual, the KN Control manual and all additional materials supplied with the boiler. Failure to do so can result in severe personal injury, death or substantial property damage. Start-up/service history Before leaving the installation site after start or service, fi ll out the Start-up/service history information. KN USER’S CONTROL MANUAL The KN boiler — HeatNet® control Control overview Th e KN HeatNet control monitors boiler temperature and limit circuit inputs, modulating boiler fi ring rate to meet demand. Th e control uses microprocessor electronics, watching time-average response from the system to anticipate how much heat the system needs. This manual covers the application, installation, operation and maintenance of a KN series boiler. long life for which this boiler was designed, these instructions must be read, understood and followed. The KN boiler series has been design certified by CSA for use with natural gas under the latest revision of.
When air is taken from the boiler room (no air pipe connected to the boiler air inlet fi tt ing), follow the instructions in the KN Boiler manual to ensure the boiler room has proper openings for combustion air and ventilation. Vent piping Category II IV venting only. This manual covers the application, installation, operation and maintenance of a KN series boiler. long life for which this boiler was designed, these. instructions must be read, understood and followed. The KN boiler series has been design certified by CSA. for use with natural gas under the latest revision of. KN USER’S CONTROL MANUAL The KN boiler — HeatNet® control Control overview Th e KN HeatNet control monitors boiler temperature and limit circuit inputs, modulating boiler fi ring rate to meet demand. Th e control uses microprocessor electronics, watching time-average response from the system to anticipate how much heat the system needs.
Also read and follow: KN-Series Gas Boiler Installation and Operating Instructions This manual is intended only for use by a qualified heating installer/. 21 de mar. de I looked in the manual and this manual for the KN states the regulator needs to be 10 pipe diameters (instead of feet) from the gas valve. My. Drain (when provided for);.: Tank temperature;.: Boiler temperature. The wash cycle can be selected by pressing the key (START) for more than 5sec. The cycle.
0コメント